Regin MNG Electric Zone Valve Actuator

Product Description

Regin MNG Electric Zone Valve Actuator

Regin MNG Electric Zone Valve Actuator, the reliable 24V electric zone valve actuator is a two position electro thermic actuator that is set to normally close or normally open. It utilizes a gearless electro thermic operator that operates with low voltage at 24 VAC or DC.

Under continuous power, Regin MNG Electric Zone Valve Actuator stroke start time is less than ten seconds and continuously travel from full open to closed in approximately three minutes. Regin MNG Electric Zone Valve Actuator is made of corrosion-resistant components with an outstanding product life. Regin MNG Electric Zone Valve Actuator is designed for use with MNG Zone Valves

Regin MNG Electric Zone Valve Actuator

Features;

• Noiseless operation
• Low power consumption
• High close-off pressures
• Position indicator
• Low cost and compact size
• Spring return

Specification;

• Operating voltage 24 VAC/DC, 50/60 Hz ±20%
• Max current 3 VA (6 VA inrush)
• Operating current 125 mA (250 mA inrush)
• Full stroke time Approx. 3 min (from cold start)
• Ambient temp 23° to 122°F (-5° to 50°C)
• Max differential 4.5-60 psi (0.3-4 bar), pressure depending on valve
• Actuator stroke 0.177″ (4.5 mm)
• Cover material Polycarbonate fiberglass rated to 284°F (140°C), fire retard and plastic
• Enclosure NEMA 3 (IP 43) vertical
• Force 28 lb (125N)
• Weight 0.45 lb (0.2 kg)

Installation Instructions:

To protect the Regin MNG Electric Zone Valve Actuator during new construction, valve bodies should be installed before the actuators are mounted. DO NOT  mount  the  operator  lower  than  horizontal  unless  a 371555  shield  is  installed.  The  actuator  should  be  firmly mounted and hand tightened. To change from N.C. to N.O., remove  the  position  indicator  cover  and  red  pointer.  Then, remove and discard the black stem spacer. With a thin stan- dard screwdriver, push firmly on the stem slot and twist CCW 60°  until  the  stem  pops  outward  with  the  triple  tabs  in  the three slots. Lastly, replace the position indicator and cover.